Modifying the 20V stiffener plate to fit the RWD MR2:
I also decided to use the tranny stiffener plate, this is an aluminum brace that connects the bottom of the tranny with the engine on the 20V. If you use it you need to cut off a small portion on both sides so that the drive-shafts can clear. Its not a large section, the pictures show how much. A hacksaw and a dremel is enough to get this job done.
Modifying the 20V stiffener plate to fit the RWD MR2:
I also decided to use the tranny stiffener plate, this is an aluminum brace that connects the bottom of the tranny with the engine on the 20V. If you use it you need to cut off a small portion on both sides so that the drive-shafts can clear. Its not a large section, the pictures show how much. A hacksaw and a dremel is enough to get this job done.